SOLD this guy off today to cat named Vince from Santa Ana. He plays in the noise group Sloppy Cock and you can see them and the marsonna live Dec. 17th at Santa Ana Noise Fest 3. Back to the noise box, I removed the...

Taking a break from the "massive project" to bend an old Mr. Mike some dude sent over.. here are the first couple of bends I've found.. I also found a master pitch control.. will post more when I get it finished. UPDATE 10.07.11 Shipped back to his...

This is a Casio SA-20 I was recently commissioned to bend by Joe Diliberto of Tonal Eclipse Productions. When it came to me it had an RCA patch bay that I knew couldn't possibly function and oh was I right. It has all the same...

I scored a super clean Yamaha DD-5 this morning at one of my favorite local swap meets. Box, adapter, sticks, manual, and all. The box is a little worse for wear but it does not matter cause the previous owner used it to keep this...

Now offering Alesis Hr-16 button and battery repair service. This is a must for anyone who has an older HR-16 that will not hold patterns or has buttons that do not function properly. Breathe new life into your old HR-16 for the low price of...

I am one of many lucky artists to be featured on the new Dislocated Tones "Compound Fractures" release. Dislocated Tones is a new net label based in U.K. dedicated to releasing music by artists that are outside of the mainstream. Far outside of the mainstream....

I got the Korg back together today and the buttons are all working 90% better.. the open hi-hat is a little unresponsive at times, so when I take it back apart to bend I'll be sure to address that. The terrible buzz and hum is...

I made this image a few years ago when I was working on a Roland TR-505 for Igor Amokian, at the very least it should point you in the right direction if you have one of these but are hesitant to open it up. It...

                  Looks like someone poured a coke on top of this bad boy, dust bunnies have invaded as well. Time to give this board a good cleaning. Normally I would not hesitate to bust out the WD-40 for this job, but the "buttons" are actually plastic...